LG Ice Maker Repairs in Florida
An LG ice maker that has stopped producing cubes is usually a water-supply, sensor or heater fault rather than the ice maker itself. Reyds attends LG side-by-side and French door ice makers across Florida, testing the water inlet valve, the ice-maker module, the feeler arm and the main board to find the real cause.
- Avg. response time55–95 minutes
- Lead technicianSipho
- CoverageFlorida
- Parts stockedOn van
› Defrost heater replaced · roodepoort
› Ice maker valve replaced · Florida
Common Symptoms in Florida
- No ice produced for 24+ hours
- Ice cubes stuck or clumped together
- Ice maker jammed with a single block of ice
- Water dispenser works but ice maker doesn't
- Er IF or Er IS error code
What Causes This Fault
- Frozen water line to the ice maker
- Failed water inlet valve (partial or full)
- Ice-maker mould heater or thermistor failed
- Feeler arm stuck or out of position
- Main board not calling for ice
Our Repair Process
- 01Verify water pressure to the fridge and through the valve
- 02Check for a frozen fill tube and thaw if required
- 03Test water inlet valve coil resistance
- 04Cycle the ice maker and observe the harvest
- 05Test mould heater and ice-level sensor
- 06Replace the confirmed failed component
When to Call a Technician
If your ice maker has been empty for more than a day and the water dispenser still works, book a call-out — running a stuck ice maker can burn out the mould heater.
Frequently Asked Questions
Why does my ice maker freeze up?
A slow, dripping water inlet valve over-fills the mould and freezes the fill tube. Replacing the valve usually solves recurring freeze-ups in Florida homes.
Should I replace the whole ice maker module?
Not always. The valve, fill tube, mould heater and sensor are all individually replaceable. We test each before recommending a full module swap.